.

## How is electrical degree calculated?

That means that 360 electrical degrees will occur when the shaft has rotated only 120 (3603) mechanical degrees. You can see that each time we divide the mechanical degrees by the number of pole pairs (or, the number of poles divided by 2). So in general we can say that **θe=P2θm.**

## What is the electrical degree of 6pole stator of motor?

Electrical Degrees and Mechanical Degrees

Two stator poles produce one cycle of power. Each pole contains **180 electrical degrees**. A two-pole stator has the same number of electrical degrees as mechanical degrees. In a four-pole stator, there are 720 electrical degrees in the 360 mechanical degrees of the stator (Fig.

## How the voltage is received in the rotor of induction motor *?

In a three-phase induction machine, alternating current supplied to the stator windings energizes it to create a **rotating** magnetic flux. The flux generates a magnetic field in the air gap between the stator and the rotor and induces a voltage which produces current through the rotor bars.

## What is meant by electrical angle?

[ə′lek·trə·kəl ′aŋ·gəl] (electricity) **An angle that specifies a particular instant in an alternating-current cycle or expresses the phase difference between two alternating quantities**; usually expressed in electrical degrees.

## What is synchronous speed and it’s formula?

The synchronous speed of an AC motor is determined by the frequency of the source and the number of poles. The RPM is **calculated by multiplying the frequency times 60 and dividing by the number of pairs of poles**. … Actual speed of the induction motor will be less than the synchronous speed.

## Where is concentrated winding used?

The concentrated winding is employed **where the number of slots on the armature is equal to the number of poles in the machine**. This armature winding of alternator gives maximum output voltage but not exactly sinusoidal.

## What is the working principle of split phase motor?

Working of Split Phase Motor

At the time of starting, **both the main and starting windings should be connected across the supply to produce the rotating magnetic field**. The rotor is of a squirrel cage type and the revolving magnetic field sweeps part the stationary rotor, inducing emf in the rotor.

## What is the speed formula for AC motor?

To calculate RPM for an AC induction motor, you multiply the frequency in Hertz (Hz) by 60 — for the number of seconds in a minute — by two for the negative and positive pulses in a cycle. You then divide by the number of poles the motor has: **(Hz x 60 x 2) / number of poles = no-load RPM**.

## What is 120 in motor speed formula?

The equation for calculating synchronous speed is: **S = 120 f/P speed = constant (120) times frequency of power source (60 Hz) divided by number of poles used in the motor (P)**.