It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you’re in luck!
Is there a reset button on an electric golf cart?
Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn’t repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.
How do you troubleshoot an electric golf cart motor?
Expose the motor (you’ll probably need a screwdriver to remove the cover), and look for a red button. It is usually near the main power source, where most of the wires are connected. Once you’ve pressed the button to reset the motor, reassemble the cart, charge up the batteries, and give it a test run.
How do you reset the motor on a EZ Go golf cart?
Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button. Push the button to reset the motor.
How do you know if your golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won’t start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
Why does my electric golf cart have no power?
Guru: Lou, the issue you are having can be caused by a battery not holding its charge or a compromised battery cable connection. First, check the battery cables and their connection at the batteries. If all seem to be good, move on to testing the batteries. Second, run the car until it starts the issue.
What can go wrong with electric golf carts?
What Are the Most Common Problems With Electric Golf Carts?
- Batteries That Break Down or Lose Charge. If your golf cart won’t start, the first thing we suggest it checking your battery! …
- Solenoid Breakdowns. …
- Issues With the Ignition. …
- Speed Controller. …
- Direction Switch.
How do you test an electric golf cart motor?
If the speed seems to be off, or your cart gives off a burning wire smell, your golf cart motor might have a problem. Using a multimeter, a jumper wire, and a 12-24 volt power source, you can test the condition and functions of your golf cart motor without removing it from the cart.
Should I leave my golf cart plugged in all the time?
Leaving your golf cart plugged all the time is not an ideal maintenance practice for the longevity of your battery. If you are an individual owner, experts recommend unplugging your golf cart battery when it’s fully charged. A golf cart battery is like the fuel in your car; it needs to be at its optimum all the time.
Do electric golf carts have fuses?
Golf carts serve a greater need than just driving on the golf course. … Many hardware stores carry fuses that are compatible with those in a golf cart. A blown fuse can also mean there is an electrical problem. A blown fuse requires a thorough examination of the circuit system to locate the problem.
How long do electric golf cart motors last?
When properly taken care of, the typical gas or electric golf cart motor can last many, many years (20 to 30+). But the fact of the matter is, many people neglect taking proper care of their golf cart motor.
How do you troubleshoot a golf cart controller?
Here are 5 steps you should follow for a DIY fix to your golf cart’s speed controller.
- Flip the maintenance switch. …
- Reset the battery cable. …
- Check your connections. …
- Test the solenoid. …
- Check your controller’s power output.
Why does my ezgo golf cart lose power?
If your cart is experiencing loss of power, or inconsistent power availability, your battery connections may be loose, frayed or corroded. … If any appear significantly frayed or broken, you will need to replace the battery cable. If they look intact, twist each battery connection back and forth to test for tightness.